Vicon VCR496-P, Installation & Operation Manual

Page: 39 / 48

2. Configuring the time lapse VCR
l
setting
Set the RS-232C interface board setting by using the on menu of the VCR.
Press the DISPLAY button to display MAIN MENU.
. “MAIN MENU” will appear.
Turn the JOG dial to select “FIRST TIME SET UP”.
q
Turn the SHUTTLE ring to the right.
l
“FIRST TIME SET UP” menu will appear.
Turn the JOG dial to select
l
If “RS-232C interface board” is installed correctly, item will appear
on “FIRST TIME SET UP” menu.
Note: If the item does not appear, press the RESET button on the rear
panel of the VCR.
Turn the SHUTTLE ring to the right.
l
setting menu will appear.
Select the parameter to be changed by using the SHUTTLE ring. Change its
value using the JOG dial and then use the SHUTTLE ring to store the new
value.
1. SETTING TRANSMISSION RATE
TIME DATE SEARCH
TIMER PROGRAM
RECORDING SET UP
REAR TERMINAL
MAINTENANCE
F I R S T T I M E S E T U P
Use select,
Press lo
SET UP
TAPE END
QUASI V-SYNC
T A P E L E N G T H
E-180
A D J U S T
When the JOG dial is turned to the right, the display will be switched in the order of
. . . .
2. SETTING DATA BIT LENGTH
When the JOG dial is turned to the right, the display will be switched in the order of 8 BIT 7 BIT 8 BIT
3. SETTING STOP BIT LENGTH
When the JOG dial is turned to the right, the display will be switched in the order of 1 BIT 2 BIT 1 BIT . . . .
4. SETTING PARITY BIT
When the JOG dial is turned to the right, the display will be switched in the order of NONE ODD EVEN+
NONE . . . .
Note: The Parity bit cannot be used when the DATA BIT LENGTH is set to 8.
5. SETTING DELIMITER&END> (Setting a character marking the end of a command.)
When the JOG dial is turned to the right, the display will be switched in the order of CR CR-LF CR
. . . .
6. SETTING (Setting a character marking the end of a status or error code.)
When the JOG dial is turned to the right, the display will be switched in the order of CR CR . . . .
7. SETTING VCR ADDRESS (Setting the ID number of the VCR)
When the JOG dial is turned to the right, the screen display will be switched in the order of NONE VCR01
VCR03 . . . VCR14 VCR15 NONE . . . .
When controlling only one VCR via the personal computer, “VCR ADDRESS” is set to “NONE”.
When two or more VCRs are to be controlled in series, each VCR must have a unique VCR ADDRESS (from
VCR01 to VCR1 6).
Note: Set the communications parameters (items 1 6 above) to the same values as the controlling personal
computer or otherequipment. Each VCR must have the same settings when multiple VCRs are
connected.