Creating a Configuration
|
3-33
Pilot Plus
XX200-00
Independent Stack Mode Example
In Independent Stack Mode, each monitor has its own stack, as shown in the
following figure. The figure is divided into four parts: A, B, C and D. Functions
that affect display order act upon individual alarm monitors. For example,
acknowledging alarm video removes it from the stack of the alarm monitor
that is displaying the alarm video, but does not affect the stacks of any other
alarm monitors unless specifically programmed to do so..
The initial conditions are:
Independent
stack
mode
FIFO (first-in, first-out) order for monitors 1 and 3; priority order for
monitor 2
Acknowledged alarms will NOT be cleared from all monitor lists
Alarm 01 is activated before alarm 02
Alarm 02 has a higher priority than alarm 01
Part A of illustrates the Edit Alarm Call-Up screens for two alarms. Part B
illustrates the video from specific cameras at specific preset positions. All of
the alarms shown in Part B are associated with either alarm 01 or alarm 02
except for the video from camera station 10 at preset 01. When alarms 01
and 02 are activated, alarm 01 displays on monitor 01 because the alarm
order was established in the initial conditions as FIFO.
In Part C the Alarm Order for monitors 01, 02 and 03 is shown. Monitor 02 is
set to Priority, so alarm 02 displays on monitor 02. Monitor 03 displays only
alarm 02 because this monitor was not included in the Edit Alarm Call-Up for
alarm 01, and monitor 03 has no camera associated with alarm 01.
In Part D it is shown that alarm 02 is acknowledged from monitor 02, it is
cleared from monitor 02’s stack only. Because of the specified initial
conditions, monitors 01 and 03 are not affected.
Summary of Contents for PILOT PLUS V1544
