Applying Power
The switching power supply in the Vi422 allows the unit to be operated from 90-265 VAC at 50-60 Hz.
Perform the following procedure to apply power to the unit.
1.
Perform the steps in
Power
page
2.
Plug the power cord into the V1422 rear connector panel. Refer to Figure 3 on page 9. Plug the power
cord into the appropriate power source (90-265 VAC, 50-60 Hz).
3.
Locate the power switch on the rear panel and turn the unit on by placing the power switch in the “I”
position.
4.
Apply power to all CCTV system components, referring to the appropriate instruction manuals.
Programming the VI 422
The Vi422 configuration file must be developed before operation. Refer to
CPU-Based
and
Entering the
ID and
If at least one user has been defined for the system, the LCD will display as follows when the Vi422 is initially
powered or rebooted.
VICON INDUSTRIES INC.
SYSTEM LOGON *
ENTER
ID
A valid identification number must be entered before the programming screens can be accessed and the
system can be operated. Enter the ID using the local numeric keypad and press the HOME key. Refer to
Figure 9 on page 23 for the location of these keys. Note that if the user identification number is assigned to an
administrator, a
will also be requested:
VICON INDUSTRIES INC.
* ADMINISTRATOR *
ENTER
- - - - - - - - - -
Enter the
using the numeric keypad and press the HOME key. If the
was valid
(programmed for an administrator as discussed in
CPU-Based
System
the Vi422 will now be available for system operation and programming. If an
invalid
is entered, both the
ID and the
must be entered again.
Press and
key and then Dress fhe
key exit
menu system.
I
24
l
Operation
X826 Rev 798 NOVA V1422