Installing the Tilt Stand
The V1422 may be mounted in a rack or used on a desk-top. A tilt stand is included in the accessory
kit
to
elevate the V1422 when used in desk-top mode. The tilt stand is shown in Figure 9 on page 23 of the
in this manual. The tilt stand locks in position for elevation or folds flat against the bottom of
the unit when elevation is not required. Perform the following procedure to install the tilt stand.
1.
Select the following from the accessory kit:
l
tilt stand
l
right mounting foot for tilt stand
l
left mounting foot for tilt stand
l
four
6 screws
l
two square adhesive-backed rubber feet.
2.
Two sets of screw holes on the bottom of the Vi422 will be used to mount the tilt stand feet. These holes
are located approximately 1 inch from the front panel of the Vi422 and are approximately 8 inches apart
from each other. Choose the right mounting foot (identified in Figure 2) and attach it to the right set of
holes using two of the
6 screws from the accessory kit.
Note: When
stand
use,
the
and
feet as
stand fo
toward
rear connector
order to
stand
the front of fhe
feet on
sides of
for
step choose fhe
foot as
if
on fhe
of the
LEFT MOUNTING FOOT
RIGHT MOUNTING FOOT
Figure 2
Right and Left Mounting Feet for Tilt Stand
3.
Inset-t one end of the tilt stand into the groove of the installed right mounting foot. Insert the other end of
the tilt stand into the left mounting foot and position the left mounting foot over the left set of screw holes.
Using the remaining two
6 screws, attach the left foot to the V1422.
4.
Remove the adhesive backing from the square rubber feet and attach them approximately 12 inches apart
and approximately 1 inch from the rear connector panel of the V1422.
8
l
Installation
X826 Rev 798 NOVA V1422