not exist, refer to the receiver or distribution line control instruction manual and the physical connections at
the terminal block or connector and construct a chart.
Refer to Table 9 and carefully insert the appropriate pin into the appropriate
connector receptacle.
Refer to Figure 7. For example, if a red conductor at the receiver-end of the cable has been connected to
response out
the pin connected to the red conductor at the
of the cable should be inserted
into receptacle number 1, which corresponds to response in +. Complete the chart in Table 9.
fe
of
a
made, a
must be used fo remove
ph.
does not
fool:
w/;//be connected
3, and
9.
Refer to Table 9 and insert a pin into each receptacle listed, using one conductor set in the dual cable for
pins 1, 2, and 6, and one conductor set for pins 3, 7, and 8. Refer to Figure 7 on page 15. If Belden 9182
was chosen, use one cable for pins 2, and 6, and a second Belden 9182 for pins 3, 7, and 8. Complete
the chart in Table 9, as it will be needed for connections to the receiver or distribution line control which
will be connected to jack J4.
Table 9
Receiver Connections
Receptacle
V1422 Signal Name Connect to Receiver
Color
Number
in’
Signal Name
. . .
Ground (shield)” Ground (shield)
Command out
Command in
__
I
Response in
10. Insert the inner shield into the grooves of the connector. Refer to Figure 5a on page 13.
11. Close the inner shield. Insert the outer shield into the grooves of the connector. Refer to Figure
and c.
12. Close the outer shield until the tabs snap over the tabs on the inner shield. Refer to Figure 5d.
13. Slide the ferrule until it covers the end of the closed shields. Crimp the larger end of the ferrule to the
cable(s).
14. Connect the assembled cable to jack J4 on the V1422 rear connector panel. Refer to Figure 3 on page 9.
Vicoax Receivers
Vicoax receivers communicate over video cabling and, unlike NOVA receivers, do not require additional
cabling for command responses. Table 10 lists the Vicoax receivers sold by Vicon at the time this manual was
printed. Refer to the appropriate receiver instruction manual or contact a Vicon sales representative for
changes and updates to this list.
Table 10
Vicoax Receivers
Mini
18
l
Installation
X826 Rev 798 NOVA V1422