Vicon NOVA 1500, Instruction Manual

Page: 34 / 54

26
•
V1500CDU Communication Distribution Unit XX087-02 Rev 503 V1500
Titler Module
The V1500CDU-TDT (typical configuration) and V1500CDU-HSB-TDT (hot standby configuration) provide
two ports for performing time/date/titling functions. The V1500CPU sends titling commands to the titler
modules, which are connected to the V1300X-TCC Time/Date/Titlers. The V1300X-TCC superimposes the
titling information upon the designated video outputs. Up to 64 monitors may be connected to each port of the
V1500CDU-TDT or V1500CDU-HSB-TDT modules by connecting the monitors to the slave units as shown
below. Refer to Instruction Manual X554 for more information on the V1300X-TCC Time/Date/Titler. Cables
are supplied with the V1500 time/date/titler module and are listed in Table 15 of the previous section.
Note: Port 1 is used for monitors 1-64 and port 2 is for 65-128.
TDT
CONTROL
POR
T
1
TDT
CONTROL
POR
T
2
V1300X-TCC
Master Unit
VICON
V1300X-TCC
V1300X-TCC
Slave Unit
VICON
V1300X-TCC
VICON
V1300X-TCC
Master Unit
VICON
V1300X-TCC
V1300X-TCC
Slave Unit
VICON
V1300X-TCC
VICON
Part No. 1251-3273-01
Part No. 1251-3273-01
Up to 64 monitors may
be connected to each
port of the titler module.
Figure 20 - Connections to the Titler Module
Note: The titler card is a parallel card. All parallel cards have green extractor tabs for easy identification. Should you ever
need to replace a card, open the card cage front panel, locate the green extractor tabs and then refer to the rear
panel to identify the card. If you have labeled the cards as discussed in the V1500CDU Communication Distribution
Unit section of this manual, simply refer to the card labels to identify each card. You may exchange a defective
parallel card at any time without removing power to the card cage (“hot swap”).