XX128-02-00 Rev 904 Kollector Pro Network Digital Video Recorder
Installation
••••
9
•
=
Insert the female end of the provided 120VAC Power Cable into the recorder's Power Receptacle. Do
not connect the remaining end to a power receptacle until instructed. If using 230VAC power, it will be
necessary to obtain a suitable power cord for use. This cable is a standard computer 230 VAC power
cord.
•
=
Turn ON the Power Switch.
2. Connect the monitor to the power source.
Step 2: Connecting External Hardware to Termination Boxes
The connection of external hardware to the Termination Boxes requires simple hand tools. Do not apply
power or plug-in the recorder to any outlet until instructed to do so.
WARNING:
Disable the AC power to prevent installer injury and damage to the unit.
With the Termination Boxes mounted permanently, connect external devices as follows:
Communications (PTZ Control)
To connect a PTZ camera control to the Kollector Pro:
1. Using a twisted-pair cable as defined in
Chapter 9, Twisted-Pair Cable Recommendations
, prepare a
4-conductor plus shield type cable by stripping the ends back for use.
2. Connect the PTZ wires to the Termination Box connectors (either TX+ and TX- or RX+ and RX-,
depending on the type of the camera (refer to Figure 3-3 on page 10). Ensure that you connect the wires
to the correct polarity.
3. Install the other end of this cable into the device it will communicate with, for example, a V1400X-IDL,
Camera Dome or other type of receiver.
4. Connect the RJ45 cable to the appropriate channel in the rear panel.
Sensor Input
When using SMSR connectors to connect devices to the Kollector Pro, refer to the guidelines described
below, according to the specific device type.
To connect a sensor to the Kollector Pro:
1. Using a twisted pair cable as defined in
Chapter 9, Twisted-Pair Cable Recommendations
, prepare a
2-conductor type cable by stripping the ends back for use.
Summary of Contents for Kollector Pro
Page 2: ......