29
EN
16624471_en (04/2005)
4.
Setting work
Danger!
All jobs to be carried out only when
engine switched off and machine at a
standstill. Remove the ignition key!
4.1
Tine setting.
Check the tine setting and readjust if necessary:
unscrew hexagonal nut (c) and locknut (d)
adjust tines by adjusting the stopper screw (x) so
that the gauge is parallel for (a) and (b).
Typ 6592:
Angle y = 97°
Typ 6593:
Angle y = 92°
Tighten hexagonal nut (c) and locknut (d) again.
The torque for fastening the tines (c) is 120 Nm.
Caution!
The stopper screw (x) must be positioned
at the tine eyelet so that the tine cannot
become misadjusted.
4.2
Wheels
If the wheels have to be changed, the wheel nuts should
only be tightened with 20 Nm to prevent damage to
the plastic rings.
Check tyre pressure regularly: 1.5 bar
4.3
Vibration pads
The vibration pads mounted on both sides of the
headstock base and middle machine guarantee quiet
running of the machine at work, without vibrations.
When the dampening effect abates, the spring washer
packages „a“ are to be tightened to increase the
dampening effect. To do so, tighten the nuts.
(1/4 turn on a nut corresponds to approx. 200
N = 20 kg)
.
a