Crate packaging
39
Fitting the pendulum
support
Fitting the pendulum support to the frame on each side of the
machine:
Push the pin through the pendulum support and bracket.
Place a washer on each side of the pin.
Secure the pin on both sides with spring cotter pins.
For fitting the pendulum support to the bearing housing, see
The pendulum support is set to the correct position using an adjusting
screw. The maximum length is 900 mm.
Raise the machine to the headland position.
Turn the rotor by hand to check that it is rotating correctly.
Distance from possible collision points: min. 150 mm.
Using the pendulum support, adjust the position of the rotor.
m
ax
. 9
00
m
m
Adjusting screw
1
2
3
4
No.
Quantity
Part
1
1
Pendulum support
2
1
Pin
3
2
26 x 38 x 2 washers
4
2
Spring cotter pins
Checking the clearance distances
In the headland position, check the distances of the tine arms from
possible collision points. Correct the distances using the pendulum
support. Otherwise, the machine may be damaged.
150 mm
150 mm
150 mm