Vicks WarmMist, Use And Care Manual

Page: 3 / 19

4 5
1. Remove From Box. Remove packaging material. Set aside instruction manual. Recycle
packaging materials or save for storage.
2.
Remove twist tie from power cord and extend power cord full length. DO NOT OPERATE WITH
POWER CORD COILED OR TWIST TIE IN PLACE.
3-4. Ensure Proper Assembly. Make sure Mist Chimney and Water Tray are securely in place
and the blue latch is engaged.
5. Select a firm, level location at least 12" (30cm) from any walls.
Place the humidifier on a water-resistant surface.
Steam should be directed away from any walls, bedding or furniture.
Kaz will not accept responsibility for property damage caused by
water spillage.
Step 3
Filling / Refilling
NOTE: TANK SHOULD BE CARRIED USING TWO HANDS. ONE HAND USING CARRYING HANDLE
LOCATED ON TANK’S TOP AND OTHER HAND SHOULD SUPPORT THE BOTTOM OF THE TANK.
WARNING ! : KEEP OUT OF REACH OF CHILDREN.
This product produces HOT STEAM and should be placed in an area
not
accessible to children
or pets with the power cord also securely out of reach.
Operating Instructions V750 Series Setting Up Your Vicks Warm Mist Humidifier
1. Remove Tank by grasping handle and pulling up. Remove Tank Cap located on bottom of
Tank by turning counter clockwise.
2. Fill Tank with cool water. Do not fill with warm or hot water.
3. Replace Tank Cap by turning clockwise to screw back in place. DO NOT OVER-TIGHTEN. Place
Tank back on humidifier base.
RESET:
1.
When your humidifier is out of water the refill light will illuminate
2.
Turn the humidifier off, wait 15 minutes, refill Tank, and turn
humidifier back on.
Liquid Inhalants such as Vicks VapoSteam
®
or Kaz Inhalant can be used in the medicine cup.
ONLY USE LIQUIDS THAT ARE RECOMMENDED FOR THIS TYPE OF HUMIDIFIER.
1. Add 1 TB (Table Spoon) inhalant to the medicine cup.
2. Note: Some residue from inhalant may be left in medicine cup after use. With the humidifier
turned off, unplugged and cooled for at least 20 minutes, gently wipe residue from medicine cup.
3. DO NOT ADD LIQUID INHALANTS OR ANY ADDITIVES OTHER THAN THOSE
RECOMMENDED BY THE HUMIDIFIER MANUFACTURER TO THE WATER. DOING SO CAN HAVE
ADVERSE EFFECTS ON THE HUMIDIFIER.
Using Liquid Inhalant
Step 2
Step 1
Step 1
Step 2
Step 2
Step 4
Step 3
Step 3
Refill Light
Step 2
Step 5
Step 1 Liquid Inhalant Step 3
1. Power: With the power switch in the OFF position ( ), plug the filled humidifier into a
polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET ; It will
only fit one way. DO NOT plug in humidifier with wet hands to avoid electric shock.
2. Output: Set output control to high ( ) or low ( ).
Indications your humidifier is operating are that the green nightlight on the control knob will
illuminate and after 1-2 minutes your humidifier will produce a visible steam.
3. Humidity Level: Once you have reached a comfortable humidity level your humidifier
should be turned to the low setting. A comfortable humidity level is between 40-60%.
To monitor your humidity level it is recommended you use a hygrometer such as the Vicks
V70 or V70-CAN model. If you notice condensation on the walls or windows you should turn
your humidifier off as your humidity level is too high.
4. CAUTION: DO NOT remove the Mist Chimney, Removable Tray, Water Tank or Medicine
Cup when humidifier is in use or for at least 20-30 minutes after unit has been turned off
and unplugged.
CAUTION: WHEN MOVING HUMIDIFIER. TURN HUMIDIFIER OFF, UNPLUG and WAIT 20-30
minutes.
DO NOT OPERATE YOUR HUMIDIFIER WITHOUT THE TANK IN PLACE OR IF THE
UNIT IS EMPTY. DO NOT OPERATE YOUR HUMIDIFIER WITHOUT THE MIST CHIMNEY,
REMOVABLE TRAY, OR MEDICINE CUP PROPERLY ASSEMBLED.
Step 1
Step 4