4
5
$
The following accessories work great with your humidifier.
VEV320 Series Accessories
Vicks VapoPads
®
Provides soothing
menthol (VSP-19,
VSP19FP, VSP-19-CAN,
VSP19VPC) or lavender/
rosemary (VBR-5, US
only) vapors.
(One Menthol Sample
Pad Included)
Required
Protec Extended
Life Humidifier Filter
(PWF2/PWF2-CAN)
Removes minerals
and pollutants
from water. Helps
prevent the growth
& migration of mold,
algae and bacteria
on filter.
Protec
®
Antimicrobial
Cleaning Cartridge
(PC-1, PC-2 and
PC-1C)
Helps keep your
humidifier cleaner,
longer. Continuously
cleans and protects
humidifiers against
bacteria & mold.
Humidity Monitor
(V70 or V70-CAN)
Displays relative
humidity and room
temperature so
you can maintain a
comfortable humidity
level in your home.
The ideal humidity
level is between
40-60%.
1.
Remove packaging material. Keep this Use and Care Manual for future reference.
2.
Remove twist tie and extend power cord.
3.
Place the humidifier on a firm, level, water resistant surface at least 12" (30 cm) from any
walls.
DO NOT
block Intake Grill on base of unit.
DO NOT
place on surfaces that can be
damaged by water.
1.
Lift Motor Housing.
2.
Run Wicking Filter under cool water until saturated.
3.
Gently place wet Wicking Filter in base; do not squeeze out excess water.
Setting Up Your Humidifier
Prepare Wicking Filter
Prepare Wicking Filter
(Continued)
Filling/Refilling Water Tank
Step 2
Step 2
Step 3
Step 3
Step 1
Step 1
A Wicking Filter is required for this unit to operate.
The Wicking Filter will capture minerals from your water and will prevent “white dust.”
If you have hard water, you will need to replace your filter more frequently.
See “
Filter Care
” section for tips on prolonging the life of your Wicking Filter.
1.
Remove the Water Tank and carry to sink or tub. Turn Tank upside down and remove the Tank
Cap by turning counter-clockwise (left). You can grasp the outside of the Tank Cap or the inside
support ribs, whichever is more comfortable for you.
2.
Fill the Water Tank with cool tap water.
Do not
use warm or hot water. The Tank and Reservoir
combined hold approximately 0.8 gallons (3.0 L) of water.
Note:
The top of the Water Tank is flat so it should sit flat in your sink. If it does not fit, the large
Tank opening will allow you to tip the Tank sideways to fill.
3.
Replace Tank Cap and secure tightly by turning clockwise (to right).
4.
Carry full Water Tank back to humidifier using two hands; one hand on handle at the top of the
Tank and other hand supporting the bottom of the Tank. Take care not to push the plunger on
the bottom of the Water Tank or leaking may occur.
5.
Place the Water Tank on the humidifier Base. You will hear the water draining into the Reservoir.
Operating Your Humidifier
1.
With Power Knob in the OFF position, plug humidifier into a polarized 120V outlet.
CAUTION:
To avoid electric shock, do not plug humidifier into outlet with wet hands.
Step 1
Step 2
Step 3
Step 2
Step 1
Step 5
Step 4
Step 3