Chapter 4
Basic Testing
Running multiple tests
T-BERD/MTS/SC Getting Started Guide
March 2018
22046537, Rev. 016
Page 125
To create or maintain custom result groups
1
Set one of your result groups to
Custom
. If this is the first time you are creating a
group, the Custom result pane is empty.
2
Do one of the following:
–
To add a new group, select
New ...
.
–
To update an existing group, select the check box to the left of the group
name, then select the wrench icon.
The Configure Custom Results Category screen appears. Summary results
appear in the pane on the left of the screen, and buttons appear at the top of the
pane which allow you to display and then select results from any category for your
application.
3
Do one of the following:
–
To add results, use the buttons at the top of the left pane to specify the group
and category for the results you want to add, then highlight the result you
want to add to the category.
Select the right arrow key to move the result to the Selected Results pane.
–
To remove results, select the result you don’t want on the Selected Results
pane, then select the left arrow key to move the result back to the left pane. If
you want to delete all of the results in the category, select
Clear
.
4
Repeat
for each custom group that you want to add or maintain.
5
After you finish populating the custom category with results (or modifying the
results), press
Save
to store the category and return to the Main screen.
The Custom result group is populated.
You can use the
Delete
button on the result pane (on the Main screen) to delete a group
at any time.
Running multiple tests
If your instrument is configured and optioned to do so, you can significantly reduce your
testing time by terminating traffic over multiple circuits simultaneously. When running
multiple tests, you should power your instrument using the AC power adapter that
shipped with the instrument. If the instrument loses power while running multiple tests,
when you restore power, the instrument will only restore
the last active test application
.
NOTE: Protecting Custom Result Groups
When you protect a saved test configuration by making it read-only, the asso-
ciated custom result group is also saved and is protected.
NOTE:
Only one application can be run at a time using the CSAM, or single port
5800.
