[48]
98MANALIDP10AV Rev. A 3/23/11
7. Turn on transmitter power source.
The module replacement procedure is now complete.
NOTE
The transmitter configuration is stored in the sensor assembly. Therefore, the
configuration settings are retained when replacing the electronics module.
Recalibration, however, is recommended.
Removing and Reinstalling the Housing Assembly
To remove and reinstall the housing assembly, proceed as follows:
1. Remove the electronics module per Steps 1 through 4 in the previous procedure.
2. Remove the housing by rotating it counterclockwise (when viewed from the top)
using caution to avoid damaging the ribbon cables.
3. Reinstall the housing by reversing Step 2.
4. Reinstall the electronics module per Steps 5 through 7 in the previous procedure.
Replacing the Sensor Assembly
NOTE
The transmitter configuration is stored in the sensor assembly. Therefore, the
configuration settings must be re-entered after replacing this assembly.
Recalibration is recommended.
To replace the sensor assembly, refer to Figure 26 and proceed as follows:
1. Remove the electronics module as described above.
2. Remove the housing as described above.
3. Remove the process covers from sensor by removing two hex head bolts.
4. Replace gaskets in process covers using new gaskets.
5. Install process covers and housing on new sensor. Torque cover bolts in several even
increments to 100 N m (75 lb ft) [66 N m (50 lb ft) for bolt options B1 and D5].
6. Reinstall electronics module.
7. Pressure test the sensor and process cover assembly by applying a hydrostatic pressure
of 150% of the maximum static and overrange pressure rating (see page 2) to both
sides of the process cover/sensor assembly simultaneously through the process
connections. Hold pressure for one minute. There should be no leakage of the test
fluid through the gaskets. If leakage occurs, retighten the cover bolts per Step 5 or
replace the gaskets.
!
CAUTION
Perform hydrostatic test with a liquid and follow proper hydrostatic test procedures.
Summary of Contents for IDP10-A
