[44]
98MANALIDP10AV Rev. A 8/16/11
Testing the Display
You can access the Test Display mode by the same multi-level menu systems was used to enter
Calibration and Configuration mode. Entry to the Mode Select menu is made (from normal
operating mode) by pressing the
Next
button. The display reads
CALIB
, the first item on the
menu. Press the
Next
button three times to get to the fourth item on the menu,
TST DSP
.
Acknowledge your choice of this selection by pressing the
Enter
button. The display shows the
first test segment pattern. You can step through the five patterns by repeated use of the
Next
but-
ton. You can abort the test at any time by pressing the
Enter
button. If neither button is
pressed, the display automatically steps through the five patterns in the order shown, pausing for
about five seconds at each pattern and then return to the Online mode. The five patterns are
shown in Figure 25.
Summary of Contents for IDP10-A
