www.desatech.com
119212-01B
15
Figure 25 - Removing Louvers
Figure 26 - Spring Latches
Glass
Locating.
Holes
Spring.
Latch
Bottom.Louver
Open
Close
inStALLAtiOn
Continued
3.. Undo.latches.located.on.top.and.bottom.
of firebox (see Figure 26). Carefully swing
door.to.the.left..The.glass.door.is.securely.
mounted to the firebox with 5 screws.
INSTALLING OPTIONAL WIRELESS
HAND-HELD REMOTE CONTROL
HRC100 SERIES
NOTICE: Use only alkaline bat
-
teries (not included).
Some. fireplaces. have. the. remote. control.
already. installed.. If. a. remote. control. is. not.
installed in your fireplace see
Accessories
and Replacement Parts
,.page.29..
Installing Remote Receiver
1.. Open.bottom.louver.and.locate.the.switch.
bracket.on.the.right.
2.. Unscrew. switch. bracket.. Lean. bracket.
forward.so.you.are.able.to.access.back.
of.remote.receiver.
3.. Locate. battery. clip. mounted. on. back. of.
receiver..Slide.a.9-volt.alkaline.battery.(not.
included).through.clip.(see.Figure.27).
4.. Attach.terminal.wires.to.battery.
Figure 27 - Attaching Alkaline Battery to
Receiver
Figure 28 - Control Valve Terminals
To.Optional.
Remote.
Accessory
9-Volt.
Alkaline.
Battery.
Receiver.
Terminal.
Wires.
Battery.Clip.
To Wall
Thermostat
5.. Connect. wires. from. receiver. to. TH. and.
TPTH.on.control.valve.(see.Figure.28).
6.. Replace.the.switch.bracket.
Figure 29 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt.
Battery
Battery.
Housing
Battery.Cover
Terminal.
Wires
Remote.Control.Unit
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1.. Remove.battery.cover.on.back.of.remote.
control.unit.
2.. Attach.terminal.wires.to.a.9-volt.alkaline.
battery.(not.included)..Place.battery.into.
battery.housing.
3... Replace.battery.cover.onto.remote.control.
unit.
