020559.03
5
Installatieinstructies Boegschroeven 'Ignition Protected'
ENGLISH
• Connect the plug
connection between
the intermediate
cable and the bow
thruster.
1
4
1
4
• Fit the control panel
and connect this as
shown in the section
Electrical installation
in the manual for the
bow thruster.
D
anger
Check carefully that the bow thruster can be
allowed to turn before closing the housing!
• Test the operation of the bow thruster.
If test running shows that the thrust direction of the bow thruster is
not the same as that shown by the direction switch on the control
panel the blue (no.1) and the white (no.4) wires on the relay must be
changed round.
W
arning
Do not test the bow thruster while the ship is out of the wa-
ter unless you have checked carefully that everyone is at a
safe distance from the propeller tunnel. Never allow the bow
thruster to run for more than 5 seconds while the ship is out
of the water.
3
Fitting II
• Fit the top part of the
housing.
• Position the packing
supplied between
the contact surfaces
of the two halves of
the housing. Make
sure that the packing
is positioned prop-
erly.
• Tighten up the bolts
using a turning mo-
ment of 5 Nm.
If the motor is positioned vertically:
• Place the rubber blind nut in the hole, screw the bolt with the nut
on it in the blind nut and tighten this up sufficiently so that the
hole is sealed.
If the motor is positioned horizontally
If the motor is positioned horizontally support is absolutely essential.
• Place the rubber blind nut in the hole.
• Screw the bolt with the nut on it in the blind nut and tighten this
up until it touches the electric motor.
• Tighten the nut up against the blind nut.
• Hold the nut so that it cannot turn and then screw the bolt tighter
in order to seal the hole.
• Fit a support under the bolt.
