Vestil STRAP-WALL, Instruction Manual

Page: 6 / 7

TABLE OF CONTENTS Rev. 6/23/2021 STRAP-WALL MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Corp Page 6 of 7
INSPECTIONS & MAINTENANCE
NOTICE
Proper use, maintenance, and storage are essential for this product to function properly.
o
Inspect the unit as instructed and as frequently as instructed.
o Install the unit in a dry location.
Compare the results of each inspection to the RECORD OF SATISFACTORY CONDITION to determine
whether the unit is in satisfactory condition. DO NOT use the dispenser unless it is in satisfactory condition.
Only use manufacturer-approved replacement parts to restore the unit to satisfactory condition. Never
make temporary repairs of damaged or missing parts . DON’T GUESS! If you have any questions about
the condition of your unit, contact the TECHNICAL SERVICE department. The phone number is provided
on the cover page of this manual. Purely cosmetic changes, such as chipped paint, are not changes
from satisfactory condition. However, touchup paint should be applied to all areas where the finish is
damaged as soon as the damage occurs because exposed metal rusts. Left unaddressed, rusting could
compromise the soundness of the metal and create a safety hazard.
Inspect the following before each use :
1. Attachment to wall : Confirm that all anchoring hardware is in satisfactory condition. The mounting
bracket must be solidly attached to the wall. Tighten fasteners whenever necessary.
2. Spool holding assembly : Make sure that the retaining discs firmly clamp the spool between them. The
wing nut should be wound tightly against the outer retaining disc.
3. Labeling : All labels should be easily readable and in place as shown in the LABELING DIAGRAM . If a
label is damaged, not easily readable, or missing, contact TECHNICAL SERVICE to order a replacement.
Inspect the following at least 1 time per month :
1. Frame elements (spool frame; wall frame; intermediate frame; support stand) : Inspect welds for
cracks and other forms of damage. Inspect each element for damage, warps, and cracks. Also
examine the connection points between frame elements. Make sure that all fasteners are securely
connected. Bolt holes must not be elongated, warped, or cracked. Examine the spool peg. Make sure
that the peg is not cracked, bent, or damaged in other ways.
2. Spool holding assembly : Examine the inner and outer retaining discs, the wing nut, the threaded
rod, the rod coupler and set screw, and the rod extension. Make sure that the wing nut threads
smoothly and easily onto the threaded rod and the rod extension. Confirm that the rod and
extension are both straight and that the threads are undamaged. Inspect the retaining discs for
warps and cracks.
3.
Guide wheel assembly (see Fig. 2 on p. 5) : Examine the guide wheel assembly (roller bracket, upper
and lower rollers, spring, washers, roller pin, and cotter pins) for damage, missing, worn, or loose parts.
Inspect the guide wheel peg for cracks, bends, and other damage.
LABELING DIAGRAM
L
abel content and location are subject to change so your product might not be labeled exactly as
shown. Compare the diagram below to your RECORD OF SATUSFACTORY CONDITION . If differences
between actual labeling and this diagram exist, contact TECHNICAL SERVICE . Replace all labels that
are damaged, missing, or not easily readable (e.g. faded). To order replacement labels, or to inquire
whether your unit is properly labeled, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm or by calling (260) 665-7586 and asking for the Parts
Department.
B (on side of tool tray): Label 1153
A (on upper cross bar): Label 208
B
A