Accessories
The following accessories are optionally available for the
Vestamatic
Markise
Plus 500 V 2.0
sunshade control:
Sun sensor SS 30,
article-no. 01161210
Aluminium mounting bracket accessory
for 2 sun sensors,
article-no. 01100262
Wind meter without aluminium tube reinforcement, article-no. 01100310
Plastic mounting bracket only for wind meter,
article-no. 01272020
Plastic mounting bracket for wind meter
and sun sensor,
article-no. 01271020
Aluminium mounting bracket,
article-no. 01100510
Wind meter with aluminium tube reinforcement,
article-no. 01100410
The following versions of cover frame Jung “CD 500”, alpine-white, are available:
Combination frame one-fold,
article-no. 01400201
Combination frame two-fold,
article-no. 01400202
Combination frame three-fold,
article-no. 01400203
Combination frame four-fold,
article-no. 01400204
Combination frame five-fold,
article-no. 01400205
For surface-type installation
please use our surface-type housing,
article-no. 01030820
For controlling two drives, we recommend our isolating relays:
Isolating relays TR N2S,
article-no. 01054220
Isolating relays TR N2A,
article-no. 01054120.
G
-
50 -
Sun sensor (
S
-L ED)
LED is lit up green:
The preset sun threshold value is attained.
LED flashes green:
The sun
threshold value has been exceeded,
(reset delay is active)
but it’s not exceeded at present. The awning
drives will retract the awning after the delay
time (16 minutes) has elapsed.
LED is lit up red:
The preset sun threshold value is not attained.
LED flashes red:
The preset sun threshold value is exceeded.
(response delay is active)
If no wind alarm is applied, the sunshade drives
will extend the sunshade after the delay time
(1 minute) has elapsed.
Red LED light up
Warning! Please check the sun sensor or the
with a short break:
wiring of the sun sensor (see page 46).
Note:
Sunshade drives will only retract or extend the
sunshades when the time for response or reset
delay has elapsed without delay.
G
-
49 -
