25
■
Installation
Regulator set up
Caution
REMEMBER
Do not use without knob of regulator.
REMEMBER
Do not force rotate knob of regulator. Do not use tools to rotate knob of
regulator.
PROHIBITED
Do not put in use G-9 with neither yellow nor red LED long time (more than 10
seconds). Also, even intermittent do not do that chronically.
①
Open the lid of regulator on the top of body.
②
Rotate knob of regulator to supply appropriate amount of air to motor cartridge. The ring under knob
is stopper.
③
Grab the trigger by one hand to blow air then rotate knob of regulator by the other hand. Check the
LED on top of body nose side.
LED Color Air volume to motor cartridge
Red
Too much
Yellow
Too little
Green
Appropriate
④
Best position of knob of regulator
Firstly, rotate the knob to red LED and memory the position (angle) of the knob. Secondly, rotate the
knob opposite direction to see yellow LED and memory the position (angle) of the knob. Then back the
knob to middle of those position (angle) as best position. After getting the best position rotate and lock
lower ring to fix the knob.
①
Open regulator hood
②
Adjusting knob
③
Confirm Green LED
