11
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
To install a Bulkhead Connector
2. Mark the holes required and
drill them.
3a. Pass the mounting ring of the
Waterproof Cap through the
keyhole slot of the Cover.
3b. Slide the mounting ring (with
Cap attached) over the thread of
the Mounting Base.
6. Snap the Cover onto the
Mounting Base.
4. Pass the power cable of the
Mounting Base through the
power cable hole. (Optional
Waterproof Cap not shown)
3. If required (eg, exterior
installations) add the Waterproof
Cap in steps 3a and 3b.
1. Use the Mounting Base as a
template for marking the
position of mounting holes and
the power cable hole.
5. Add marine sealant to
waterproof the holes if mounting
externally. Secure with
fastenings of your choice.
(Optional Waterproof Cap not
shown)
Power cable
Mounting
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
1. BASE
, SOCKE
T & NUT ASSEMBL
Y
FRONT ON ANGLE AS CR
ADLE ABOVE
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
1. BASE, SOCKET & NUT ASSEMBLY
FRONT ON ANGLE AS CRADLE ABOVE
Power cable
Mounting ring
