LaserSCANNER Installation Manual
VESDA
®
2
Version 1.3
1. Introduction
Scope of this Manual
This manual is intended for installation technicians to be able to install, perform basic power and
preliminary device checks for the LaserSCANNER detector. It does not cover information for
commissioning. All VESDA equipment is to be commissioned by personnel who have attended
a VESDA accreditation course.
Use the checklist in Section 9 to verify that the installation has been correctly completed. Fill out
the details in the checklist sheet for the site and submit it to the appropriate personnel.
CAUTION
•
The Detector must only be installed by VESDA accredited personnel.
•
The performance of the system depends on the pipe network designed for the site.
Any alteration to the pipe network may alter the performance of the system. The
ASPIRE™ design tool is to be used to verify the suitability of any pipe network design
and subsequent alterations. ASPIRE™ is available from your distributor or local
Vision office
.
•
The IP rating for the LaserSCANNER is IP 30. This rating indicates the device is not to
be installed where there is the possibility of any water or liquid falling onto the
device.
WARNING
•
It is strongly recommended that the mounting bracket be used during installation.
•
The chassis assembly and Central Processor Card should NOT TO BE REMOVED or
disassembled during installation.
•
Follow the installation procedure outlined in this manual.
