Vertiv Liebert MicroPOD, Installer/User Manual

Page: 9 / 26

4 INSTALLATION
4.1 Installation on a Liebert GXT UPS
NOTE: This manual provides instructions for the Liebert MicroPOD only. Refer to your UPS manual for
UPS operation and installation instructions.
1. Unpack the Liebert MicroPOD carefully, noting the packing method. Retain the box and
packing material for possible future shipments.
2. Inspect the Liebert MicroPOD for freight damage. Report any damage to the carrier and your
local dealer or Liebert representative.
3. Verify that the Liebert MicroPOD input cord, UPS input cord and receptacle for the UPS have
the same type of configuration.
4. If you already have a UPS installed, turn off all connected loads and unplug them from the UPS.
Turn off the UPS and disconnect the input cord.
5. Attach the two Liebert MicroPOD securing brackets (optional for Liebert GXT series UPS) to
the rear of the UPS (see top of Figure 2.4 on the next page). You will need a long M3 Phillips
head screwdriver for this procedure (the torque is 7 in-lb, or 0.79 Nm). The Liebert MicroPOD
brackets have a hole to allow the screwdriver to reach the screw.
6. Next attach the Liebert MicroPOD to the securing brackets (see Figure 2.4 on the next page).
The Liebert MicroPOD can be installed to face one of three different directions utilizing the
same mounting procedures.
Vertiv | Liebert® MicroPOD ™ Installer/User Guide | 9