Vertiv Avocent HMXCC1-G2, User Manual

Page: 229 / 240

HMXCC1-G2 User’s Manual
Chapter 7 Failover for Database Replication
99
7.1.2 How to Resume the HMXCC1 Controller to Factory Default
There are two approaches to resume the controller to factory default settings:
(1) Hardware Approach: Long press the hidden reset key on the front panel of the HMXCC1 controller at least for 8 seconds.
The LED on the front panel will distinguish to start rebooting procedure. As the LED turns on and blinks with green, it indicates
that the controller has been in service.
Figure 7-12
[Note]: The LED on the front panel of the controller also represents the current role of the controller, as the table shown below:
Table 7-1
Database Replication Status No Replication (Factory Default) Master (User’s Setting) Slave (User’s Setting)
LED signal Blinking (Green) Constantly on (Green) Constantly on (Yellow)
(2) Software Approach: Go to System > Backups , click the < Restore Factory > button. The LED on the front panel will distinguish
to start rebooting procedure. As the LED turns on and blinks with green, it indicates that the controller has been in service.
Figure 7-13