4. Select the status (either
Enabled
or
Disabled
) from the drop-down menu.
5.
Select one of the following IPv4 method options:
•
Select
DHCP
to have the IPv4 IP address set by the DHCP server.
•
Select
Static
to enter the IPv4 IP address, subnet mask and gateway address manually.
•
Select
IPv4 address unconfigured
to disable IPv4.
6. Select one of the following IPv6 method options:
•
Select
Stateless
if the link is restricted to the local IP address.
•
Select
DHCPv6
to have the IPv6 IP address set by the DHCP server.
•
Select
Static
to enter the IPv6 IP address and prefix length manually.
•
Select
IPv6 address unconfigured
to disable IPv6.
NOTE: The MAC Address for the device will be displayed after this option.
IPv4 and IPv6 static routes
To add static routes:
1.
Select
Network - IPv4 Static Routes
or
IPv6 Static Routes.
Any existing static routes are listed with their
Destination IP/Mask, Gateway, Interface and Metric values shown.
2.
Click
Add
.
3.
Select
Default
to configure the default route.
-or-
Select
Host IP Or Network
to enter custom settings for Destination IP/Mask.
Enter the required Destination IP/Mask Bits with the syntax <destination IP>/<CIDR> in the Destination IP/Mask
Bits field.
4. Enter the IP address of the gateway in the Gateway field.
5.
Enter the interface name (Eth0, Eth1 or PPPx) in the Interface field when the route is by interface.
6. Enter the number of hops to the destination in the Metric field, then click
Save.
Hosts
An administrator can configure a table of host names, IP addresses and host aliases for the local network.
To add a host:
1.
Select
Network - Hosts
.
2.
Click
Add
to add a new host.
3.
Enter the IP address, hostname and alias of the host you want to add, then click
Save
.
To edit a host:
1.
Select
Network - Hosts
.
2.
Click on the IP address of the hostname you want to edit.
3.
Enter a new hostname and alias, if applicable, then click
Save
.
Vertiv™ | Avocent® ACS800/8000 Advanced Console Server Installer/User Guide
24
