Vertiv | VE Series Rack | User Manual
Installation Instructions
Baying the Rack in the Rear
1.
Similar to the front door, remove two racks and two M5 countersunk head screws from the accessory bag
and secure the rack on Rack 1.
2.
As shown in
Figure 3-25
, remove the Rack 2 right rear door, for disassembly method refer to section
“3.6.
Removing the Front and Rear Door”
, use the M5 sinking head screws to secure the rack to Rack 2.
3.
Install the right rear door of Rack 2 after baying the rack.
Rack2
Rear door
A
B
Baying Kits
Rear doorRack1
A amplified
B amplified
Baying Kits
Figure 3-25 Baying the Rack in the Rear
3.12.
Installing and Removing the Floating Nut
There are 30 sets of floating nuts and screws configured with the rack, which are used to install the user
equipment.
The installation procedures of the floating nuts are as follows:
Figure 3-26 Floating Nut Mounting
