4.1 Assembly of Countertop to Cabinet
4.0 Installation
Identify the four depressions on the top of the base cabinet where the
four feet of the cooler will locate. Lift the cooler and placed it on top of the cabi-
net, aligning the feet of the cooler to the previously located depressions.
4.2 Positioning the Cooler
There are some precautions to take when positioning and using the
PureWaterCooler™.
See the items in Figure 4a and 4b. In addition, the
cooler must be located near the supply water. Flexible 1/4-inch plastic tubing
may be used for the feed connection. Normally, this connection should be
within 25-feet of the cooler.
Important Note:
Do not cover air intake vent as this will prevent proper chilling
from occurring.
Figure 4a
Installation Precautions
Keep at least a 6 in. distance between the cooler and the wall.
6 in
Intake
vent
4
in
5
Air Intake
Vent
Figure 11
Leak Detector Electronic probes
Slide panel
backward to
remove
The electronic water leak detection system is installed in the rear left
had corner of the cooler. If a water leak should occur inside the cooler and wa-
ter collects in the leak probe tray the power will automatically be shut off.
When power is cut off due to water leak:
a. Un-plug the cooler and remove the left side panel by removing the 2
screws and sliding the panel back .
b. Remove any excess water in the bottom, lift and wipe the detection
probes dry. Replace all removed components.
c. Re-connect power to reset the leak controller in the unit and check for
leaks.
8.1 Electronic Leak Detection system
14
