5.2 Tank Drain
Occasionally, it may be desirable to drain both tanks, the hot tank and
chilling chamber. There are drain plugs on the back of the cooler. See Figure
8. First, make sure all power is off. The cooler must be moved so that the wa-
ter can be drained into a container to collect the water (about 1 1/4 gal). Re-
move the cover on top of the hot and cold water drain.
Figure 9
Tank Drain
11
6.0 Filter Monitor Operation
When water is dispensed, the green indicator light will blink. When the indi-
cator light starts to blink yellow, this indicates that 90% of the filter life has been
used and that the filters should be changed soon.
When the filters are changed, reset the filter monitor by removing and re-
placing the battery. The filter monitor sensor and battery is located in the filter
compartment. The watch style battery is partially exposed and can be removed
by pulling on the battery with finger nails or pliers. Battery should be replaced
every year or 2nd filter change, whichever is first.
4.5 Quick Connect Fittings
The standard tubing connections on the
PureWaterCooler™
are of
Quick Connect O-ring seal design and manufacture. Use the tubing and follow
the instructions below to make the connections. If you cut the tubing make sure
it is a square cut, fits squarely in the fitting, and seals properly.
Figure 6
Quick Connect Fittings
8
