Versalift VST-8000-I, Operator'S Manual

Page: 60 / 64

6-2 39026-03 02/17 VERSALIFT VST-8000/8500/9000/9500-I
DAIL
Y
VISUAL
INSPECTION
then fully extend the inner boom. Next, lower the
outer/inner boom assembly to a position slightly
below horizontal, and then retract the inner boom.
Extension and retraction of the inner boom should
be smooth. Also, listen for any abnormal noises
while extending and retracting, which could indicate
a potential problem and warrant further inspection
of the extension system. Check the roller chain
tension and adjust according to the instructions given
in Service Procedures Section of the Service and
Installation Manual.
LEVELING SYSTEM - Inspect the master cylinder,
slave cylinder, hoses, and fittings for damage,
wear, or foreign objects which may prevent proper
operation. Refer to Parts & Assemblies Section
of the Service and Installation Manual for these
components. Also inspect the protective fi berglass
covers, on each side of the slave cylinder, for cracks
or damage. If these conditions exist they must be
repaired by qualifi ed personnel before operation.
DECALS - Identifi cation, operational, and instructional
decals are installed at numerous locations on the
Versalift . These decals must be replaced if they
become lost, damaged, or illegible. Refer to the
“Decal Placement” illustration in this section.
FIBERGLASS BOOMS - Inspect the fiberglass
upper boom and the lower boom for an accumulation
of dirt that can impair the insulating value of the
fiberglass. The fiberglass outer surface of the
booms should be cleaned daily with a lint free cloth.
If the fi berglass sections require a more thorough
cleaning, refer to Service Procedures Section, “Care
of Fiberglass Booms” of the Service Manual. Check
for any structural damage in the fi berglass, such as
cracks or gouges. If these conditions exist, they must
be repaired by qualifi ed personnel.
If the unit is equipped with sealed inner boom
(optional), visually inspect the desiccant canister.
The desiccant should be blue. If the desiccant is pink
or in doubt, have the desiccant replaced or serviced.
PLATFORM - Inspect the platform for cracks in
the mounting ribs, fl oor, and fl ange around the top.
If these conditions exist they must be repaired by
qualifi ed personnel before opera tion.
ROPE - Make a thorough check of the winch rope
for abrasive wear, pulled strands, cuts, and other
defects. The rope should be clean and dry. The rope
coils should spool evenly on the winch reel. Do not
use a rope that has been subjected to shock loads.
Replace the winch rope at the fi rst sign of damage
or deterioration. Use only non-conductive rope of
the size and type specifi ed.
WINCH - Verify that the rope coils are spooling
evenly. Check for hydraulic leaks as well as leaks
from the winch drive gearbox.
SLOPE INDICATORS – The indicators are installed
at several locations on the Versalift chassis. Check
that indicators are in place and not damaged. Refer
to slope indicator installation in the Service Manual.
SAFETY DEVICES – Check visual and audible
safety devices for proper operation.
COVERS – Inspect all covers to make sure they are
in place, secure and in good condition.