20
3
3-Wire Power Cord Installation
(See Figure 3.2)
1. Remove the
Terminal Block Access Plate
on the back of the
range by unscrewing the 4 fixing
Screws
(Figure 3.1).
2. Check the correct positioning of the
Power Cord Bracket
as
per figure 3.2.
3. Assemble the strain relief in the hole on
Power Cord Bracket
.
4. Insert the
Power Cord
through the strain relief and tighten.
5. Remove the 3 wire terminal nuts and washers from the
Termi-
nal Block
.
6. Plug the terminal holes of
Power Cord
.
The
Neutral or Ground Wire
of the
Power Cord
must be con-
nected to the neutral terminal located in the center of
Terminal
Block
.
The
Power Wires
must be connected to the outside terminals.
7. Plug washers and tighten nuts securely.
Do not remove
Ground strap
.
8. Reassemble the
Terminal Block Access Plate
on the back of
the range by screwing the 4 fixing
Screws
(Figure 3.1).
4-Wire Power Cord Installation
(See Figure 3.3)
1. Remove the
Terminal Block Access Plate
on the back of the
range by unscrewing the 4 fixing
Screws
(Figure 3.1).
2. Check the correct positioning of the
Power Cord Bracket
as
per figure 3.3.
3. Assemble the strain relief in the hole on
Power Cord Bracket
.
4. Insert the
Power Cord
through the strain relief and tighten.
5. Remove the 3 wire terminal nuts and washers from the
Termi-
nal Block
.
6. Remove the
Ground Strap
from the frame of range and termi-
nal by removing its screw and cutting it as shown in Figure 3.3.
7. Plug the terminal holes of
Power Cord
.
The
Neutral Wire
of the
Power Cord
must be connected to the
neutral terminal located in the center of
Terminal Block
; the
Power Wires
must be connected to the outside terminals; the
Ground Wire
must be attached to the frame of range by using
the (Ground) identified
Grounding Screw
.
8. Plug washers and tighten nuts securely.
9. Reassemble the
Terminal Block Access Plate
on the back of
the range by screwing the 4 fixing
Screws
(Figure 3.1).
Terminal Block
Ground strap
Neutral Wire
Power Wires
Power Cord
Power Cord
Bracket
A
: D=1” 9/64 (29 mm)
B
: D=7/8” (22.5 mm)
A
B
Terminal Block
Cut Ground Strap
Power Cord
Bracket
Neutral Wire
Power Wires
Grounding Wire
Grounding
Screw
A
: D=1” 9/64 (29 mm)
B
: D=7/8” (22.5 mm)
Power Cord
A
B
Terminal Block
Access Plate
Screws
Screws
Fig. 3.1
Fig. 3.2
Fig. 3.3
Summary of Contents for VEFSGE 304 SC
Page 23: ...23...
