25
20306759
Radiance
®
Direct Vent Gas Heater
LG488
rear log
6/07
Rear Log
LG488
Fig. 42 Rear Log
Before installation, inspect ember bed burner for damage.
Do not use ember bed if damaged or cracked. Small, shal-
low surface cracks are acceptable.
1. Remove the logs from their packaging and inspect
each piece for damage. DO NOT INSTALL DAM-
AGED LOGS.
2. Install the rear log by placing it on the ember bed
toward the back of the firebox. (Figure 42) The log
should touch the back wall of the firebox. When the
log is in place, the two (2) notches on the bottom of
the log rest on the two (2) ribs on the back side of the
ember bed. (Figure 43)
LG487
ember bed
6/07
Ribs for Rear Log
Ember Bed
Rib Flat Spot for
Front Left Log
Rib and Flat Spot
for Front Right Log
LG487
Fig. 43 Ribs for Logs
3. Install the front left and right logs (Figure 44) by plac-
ing them on the ribs shown in Figure 43. Make sure
the logs line up with the flat spots on the ember bed
intended for location purposes. (Figure 43)
4. Install the left cross log by engaging the hole on the
bottom with the pin on the left side of the rear log. Set
front side of cross log on notch in ember bed. (Figure
45)
5. Install the right cross log by engaging the hole on the
bottom with the pin on the right side of the rear log.
Set front edge of cross log on ember bed as shown
in Figure 45.
ASSEMBLY AND INSTALLATION
LG490
all logs
6/07
Left Cross
Log
Rear Log
Right
Cross Log
Front
Right Log
Front Left Log
Ember Bed
LG490
LG489
front logs
6/07
Front Left Log
Front Right Log
LG489
Fig. 44 Front Logs
Fig. 45 Completed Installation
