Vermeiren Ceres 3, Instruction Manual

Page: 12 / 172

Ceres 3 Deluxe, Ceres 4 Deluxe
2015-06
Page 10
2.2 Carrying the scooter
The weight of the frame and steering unit is 43,80 kg for the Ceres 3 Deluxe and 49,85 kg for the
Ceres 4 Deluxe. This is very heavy to carry.
The best way to carry the scooter is to make use of neutral mode of the scooter. Place the scooter in
neutral and roll the scooter to the desired place.
If this is not possible you can carry the scooter by following steps:
1. Remove loose parts (basket, armrests, seat and batteries)
2. Store loose parts in a safe place
3. Carry the frame + steering unit with 2 persons to the desired place. Take the frame on the
front and the back. Only on the fixed parts from the frame.
2.3 Assembly and disassembly of the scooter
L
WARNING:
Risk of injury - Make sure that all movable parts are assembled properly.
L
WARNING:
Risk of injury - Be careful not to cut or bruise yourself with the cables.
L
WARNING:
Risk of injury - Turn the scooter off before disassembly.
L
CAUTION:
Risk of pinching - Do not place fingers between the components of the
scooter.
To disassemble, please proceed as follows:

Switch the scooter off.

Remove the armrests from the seat (see "mounting or removing of armrests" chapter).

Remove the seat (see “Adjusting the seat” chapter).

Lift off the rear plastic cover (held in place by Velcro fasteners).

Loosen the straps used to fasten the
batteries in place.

Unplug all battery plugs (not the pole
connectors) and all cable plug- and socket
connections.

Lift the batteries out.
The chassis - situated below the
seat and armrests can also be
taken apart.
To remove the front and rear parts
of the chassis from each other:

Pull out the safety pins

.

Pull apart the front

and rear

frames.
This is difficult to remove. So it
is better to leave these parts
together.
1
2
3
1 = Rear frame
2 = Front frame
3 = Safety pin