Mounting / removing ba armrest:
L
WARNING:
Risk of injury – Make
sure that both star knobs
are
engaged.
For transport the backrest of the toiletchair
can be completely removed and put on
the seat.
To mount the backrest on the toiletchair:
1. Mount the backrest tubes
in
the tubes of the frame
.
2. Retighten the star knobs
properly.
3. Swing the armrest
until they
are blocked in the armrest
support
.
To remove the backrest from the
toiletchair:
1. Loosen the star knobs
.
2. Remove the backrest tubes
out the tubes of the frame
.
3. Put the backrest on the seat for
transportation.
Footbracket (only for 9139SP):
L
WARNING:
Risk of tipping over
the toiletchair – Do not stand on the
footbracket
to get in and out the
toiletchair.
For transport the footbracket
can be
completely folded away under the
toiletchair.
1. Grasp the footbracket
.
2. Rotate the footbracket
upwards
until the tubes
touch the frame
tube
.
Mounting / removing footrests (only for
9139SPAV):
L
WARNING:
Risk of tipping over
the toiletchair – Do not stand on the
footplates to get in and out the
toiletchair. Fold the footplates upwards
to prevent standing on them.
L
WARNING:
Risk of injury –
Check that the footrests are securely
locked in place before use.
The mounting of the footrests is done as
follows:
1. Hold the footrest sideways at the
outside of the wheelchairs frame.
2. Mount the holes
of the footrest on
the pins
located on the frame.
3. Turn the footrest inwards till it clicks
in position. If this lock is a little stiff,
press the lever gently back.
4. Turn the footplate downwards.
To take off the footrests:
1. Pull back the lever
near the
footrest attachment.
2. Turn the footrest to the outside of the
wheelchair.
3. Lift the holes
of the footrest out of
the pins located on the frame
.
The toiletbucket
can now be placed
onto the guide rails
below the seat (on
the backside of the toiletchair.
Now the seat cushion
can be placed on
the seat frame. When not in use the seat
can be covered by the cushioned lid
supplied
.
Remove the bucket before
transporting the chair.
Remove and empty the bucket every
time after use.
HINT
: Pour some water in the upper edge
of the bucket. The bucket is then sealed
airtight against bad odours when the lid is
closed.
ADJUSTING INSTRUCTIONS
Adjust the length of the footrests as follow:
1. Remove the Allen screw
on the
lower end of the upper part of the
footrest.
2. Adjust the length of the footrest to a
comfortable length by moving the
hexagonal inner tube out or in.
3. Tighten the Allen screw
properly.
Minimum
