Verizon CR1000B, User Manual

Page: 35 / 194

ComputER nEtwoRk ConfiguRation
• Alternatively, you can enter the router’s PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
4. After pressing the WPS button on your router, you have two
minutes to press the WPS button on the client device before
the WPS session times out.
When the WPS button on your router is pressed, the Router
Status LED on the front of your router begins flashing blue.
The flashing continues until WPS pairing to the client device
completes successfully. At this time, the Router Status LED
turns solid white.
If WPS fails to establish a connection to a Wi-Fi client
device within two minutes, the Router Status LED on your
router flashes red for two minutes to indicate the WPS
pairing process was unsuccessful. After flashing red, the
light returns to solid white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.
CONNECTING a WI-FI DEVICE USING a PaSSWORD
1. Verify each device that you are connecting with Wi-Fi has
built-in Wi-Fi or an external Wi-Fi adapter.
2. Open the device’s Wi-Fi settings application.