NetBackup Catalog volume size in GB [default size]:
AdvancedDisk storage pool size in GB/TB [default size]:
AdvancedDisk diskpool name:
AdvancedDisk storage unit name:
MSDP storage pool size in GB/TB [default size]:
MSDP diskpool name:
MSDP storage unit name:
After you configure the storage partitions, a summary of the storage
configuration appears with the following prompt:
Do you want to edit the storage configuration? [yes, no]
Type
yes
to make any changes, or type
no
to keep the current configuration.
15
Disconnect the laptop from the
NIC1
appliance port.
Note:
If your network uses the 192.168.x.x IP address range, refer to the
following topic for important information:
See
“About NIC1 (eth0) port usage on NetBackup appliances”
on page 71.
16
After all appliances are configured and operational, you are ready to install
client software on the computers that you want to back up.
See
“Downloading NetBackup client packages to a client from a NetBackup
on page 72.
Configuring a master server to communicate with
an appliance media server
Before you configure a new appliance for the
Media
server role, you must first
update the configuration on the master server that you plan to use with it. The
changes allow for appropriate communication between the master server and the
new media server.
The following procedure describes how to configure a master server to communicate
with a new appliance media server.
To configure a master server to communicate with a new media server
1
Before the appliance is configured for the media server role, verify that the
software version is compatible with the master server as follows:
■
If the master server is a NetBackup appliance:
57
Initial configuration procedures
Configuring a master server to communicate with an appliance media server
