4
On the bottom, left, rear of the appliance verify that the LED on each power
supply is green.
5
Proceed to the next section to configure remote management.
Configuring the IPMI port from the NetBackup
Appliance Shell Menu
This section explains how to configure IPMI from the NetBackup Appliance Shell
Menu.
Before starting the IPMI configuration, obtain the following information for the
appliance for which you want to configure the IPMI:
IP address for the remote management port so that the default static IP
address of the remote management port can be changed.
IP address
Enable connectivity between your network computer and the remote
management port.
Subnet mask
Enable connectivity between your network computer and the remote
management port.
Gateway IP
address
The defaults for the remote management port are:
■
IP Address: 192.168.0.10
■
Subnet Mask: 255.255.255.0
Also review the following section on the IPMI prerequisites.
See
“Prerequisites for IPMI configuration”
on page 27.
For configuring the IPMI, you must connect to the appliance first. You can connect
to the appliance in the following ways:
65
Installation procedures
Configuring the IPMI port from the NetBackup Appliance Shell Menu
Summary of Contents for 5250
