![background image](http://html1.mh-extra.com/html/veris-industries/e50c1/e50c1_manual_1004647020.webp)
ZL0101-0D
Page 20 of 20
©2018 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 0818
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
TM
E50C1 Installation Guide
Problem
Cause
Solution
The maintenance wrench icon
appears in the power meter display.
There is a problem with the
inputs to the power meter.
See the Alert sub-menu or the Diagnostic Alert Modbus Register
146
The display is blank after applying
control power to the meter.
The meter is not receiving
adequate power.
Verify that the meter control power are receiving the required
voltage.
Verify that the heart icon is blinking.
Check the fuse.
The data displayed is inaccurate.
Incorrect setup values
Verify the values entered for power meter setup parameters (CT
and PT ratings, system type, etc.). See the Setup section.
Incorrect voltage inputs
Check power meter voltage input terminals to verify adequate
voltage.
Power meter is wired
improperly.
Check all CTs and PTs to verify correct connection to the same
service, PT polarity, and adequate powering. See the Wiring
Diagrams section for more information.
Cannot communicate with power
meter from a remote personal
computer.
Power meter address is incorrect. Verify that the meter is correctly addressed (see Setup section).
Power meter baud rate is
incorrect.
Verify that the baud rate of the meter matches that of all other
devices on its communications link (see Setup section).
Communications lines are
improperly connected.
Verify the power meter communications connections (see the
Communications section).
Verify the terminating resistors are properly installed on both ends
of a chain of units. Units in the middle of a chain should not have
a terminator.
Verify the shield ground is connected between all units.
Troubleshooting
China RoHS
Compliance
Information -
Environment Friendly
Use Period (EFUP)
Table
本表格依据
SJ/T11364
的
规定编制。
O:
表示
该有害物质在该部件所有均质材料中的含量均在
GB/T 26572
规定的限量要求以下。
X:
表示
该有害物质至少在该部件的某一均质材料中的含量超出
GB/T 26572
规定的限量要求。
(企
业可在此处,根据实际情况对上表中打
的技
术原因进行进一步说明。)
This table is made according to SJ/T 11364.
O: indicates that the concentration of hazardous substance in all of the homogeneous materials for this part is below
the limit as stipulated in GB/T 26572.
X: indicates that concentration of hazardous substance in at least one of the homogeneous materials used for this part
X
O
O
O
O
O
is above the limit as stipulated in GB/T 26572
Z000057-0B
部件名称
Part Name
有害物
质
-
Hazardous Substances
铅
(Pb)
汞
(Hg)
镉
(Cd)
六价
铬
(Cr (VI))
多溴
联苯
(PBB)
多溴二苯
醚
(PBDE)
电子件
Electronic