Verint Nextiva S2700e, User Manual

Page: 43 / 101

Verint Video Intelligence Solutions 33
Nextiva S2700e Series User Guide
5. In the Video list, select the desired transmission mode for video data. The available
values are:
†
RTP/UDP—A video mode using RTP (Real Time Transport Protocol, RFC 3550) over
UDP. It is the preferred mode for LAN environments; however, it does not guarantee
proper reception of packets. (default)
†
VSIP/UDP—A legacy mode, using the proprietary VSIP video protocol over UDP. The
preferred UDP mode is RTP/UDP.
†
RTP/TCP—A video mode using RTP (Real Time Transport Protocol, RFC 3550) over
TCP. It can be useful over WANs, Internet, or LANs needing more robust or secure
connections. This mode guarantees proper reception of packets, but could slow
down the effective frame rate to a level which is not acceptable.
†
VSIP/TCP—A legacy mode, using the proprietary VSIP video protocol over TCP. The
preferred TCP mode is RTP/TCP.
6. If you are not transferring I/O data (typically alarms) between the two selected
devices, clear Forward I/O.
7. Click Connect.
8. In the SConfigurator confirmation window, click OK.
You should now have video on the analog monitor connected to the receiver. I/O data can
also be transferred.
Configuring the I/Os
The S2700e camera provides one input and one output for generating or receiving alarms.
Use the following wires for the connections:
A typical configuration requires you plug an event sensor to the input and ground wires on
the S2700e, and your alarm system to the Out section of a receiver. For example:
Wire color Usage
Yellow (2) Output relay
Green Input
Black Ground
Ground Input
Relay Relay
-T -R