Verint Nextiva S2700e, User Manual

Page: 32 / 101

2: Mounting and Configuring the IP Camera
22 Verint Video Intelligence Solutions
4. Fasten the fastening screw of the retaining lock.
5. Tighten the two outer case fastening screws to fasten the camera into the outer case.
To complete the installation:
1. Insert the supplied silica gel into its insertion space.
2. Put back the inner dome over the video sensor module, by pressing slightly the dome
over the three clips. Be careful not to move the position of the lens.
3. Attach the fall prevention wire from the dome cover to its hook on the camera.
4. Mount the cover by aligning then fastening the three screws using the supplied wrench.
Performing the Power Supply
Connection
All camera models use either 12V DC or PoE for power. On the S2700e-VR-XT and
S2700eP-VR-XT, the heater needs a 24V AC source; it is recommended to power the heater
after the camera.
Verint offers a universal 12V DC power supply as part of your package. For any other power
supply, refer to the manufacturer documentation for the proper wiring scheme.
Note: Insert the silica gel just before putting back the dome cover. The gel loses its
effect if it is exposed to the air for a lengthy period of time.
During reconnection or reinstallation, replace the gel with a new packet.
Tip: Ensure that the fall prevention wire is not caught outside of the camera.
Silica gel