Verint Nextiva S1100, User Manual

Page: 41 / 107

Verint Video Intelligence Solutions 29
Nextiva S1100 User Guide
To generate an alarm on a transmitter, you short the input 1 dry contact and the alarm
ground. The relay output on the receiver is configured to close the contact between the two
output pins (up to 48V at 100 mA) upon alarm activation.
Performing a Hardware Reset
You can perform a hardware reset on the device. This operation will assign the factory
default settings to the device (listed in Appendix A on page 51). All user-defined values will
be lost.
Following a reset, you may need to reprogram the S1100 device for proper operation with
the other device.
To perform a hardware reset:
1. Power down the device.
2. Short the TxD and CTS wires together.
If required, check the DB-9 pinout on page 54.
3. Power up the device and wait until the normal boot-up sequence is completed.
4. Remove the short on the TxD and CTS pins.
The device is ready for use with the factory default settings.
Event sensor
Alarm Input 1 Alarm Ground
Alarm Out+ Alarm Out-
-T
-R