Verint Nextiva S1100, User Manual

Page: 35 / 107

Verint Video Intelligence Solutions 23
Nextiva S1100 User Guide
f. Using the Configuration Assistant tool, perform a basic setup on the pair of devices
(see page 33).
„
Enable the repeater mode.
„
Enter a different wireless passkey for each device.
As soon as these settings are saved, the devices are not communicating anymore,
since they have different wireless passkeys. The RF and video communication will
be re-established after the repeater is fully configured.
2. Configure the two S3100 devices making up the repeater. For the procedure, refer to
the Nextiva S3100-RP Installation Guide.
You can now install the devices in their final location.
Installing the Equipment
After configuring successfully your S1100 devices, you are ready to install them in their
final location. The installation procedure can include the setup of external antennas.
To optimize your system radio performance, carefully review the site planning information
presented in Chapter 2 on page 5.
Installing the S1100 Devices
The installation procedure is the same for all devices, regardless of their usage (with or
without a repeater).
Warning: When installing colocated wireless systems, you have to take into account the
distance limitations listed on page 11.
Warning: Always mount the device with the mating connectors pointing downwards.
Otherwise moisture may penetrate the device; the associated repair costs would
not be covered by the warranty.
To install an S1100 device:
1. To install a device on a light pole or mast, use the pole mount brackets and stainless
steel clamps provided with your shipment. For wall mounting, use the side brackets
already installed on the device.
2. If you are installing the S1100 equipment in a lightning prone environment or in a site
where large AC mains power fluctuations are a common occurrence, add additional
external surge protection to all vulnerable connections.
In such environments, vulnerable connections are those that run for a long distance
between the S1100 device and the connected equipment. For more information, see
the “Surge Protection” appendix on page 61.
3. If the S1100 equipment will be directly exposed to the sun in an environment likely to
reach 122°F (50°C), install a sun shield.
A derate of 13°F (7°C) is required to protect the equipment.
4. If required, install an external antenna on the device (see page 27).