Verint Nextiva S1100, User Manual

Page: 36 / 107

3: Configuring and Installing the Device
24 Verint Video Intelligence Solutions
5. Apply the supplied silicone grease on the mating connector of the CAB9P cable and on
the main connector of the device. For the detailed procedure, refer to the leaflet
shipped with the cable.
Warning: Failure to apply the grease will void the warranty.
6. Connect the CAB9P cable to the S1100.
To properly install the cable connector on the device, you have to turn until you feel a
positive click.
7. Plug the BNC video connector of the CAB9P cable on the target device (camera or
monitor).
8. If required, perform the serial connection to the target device (see page 24).
9. If you are using a junction box (JBOX code), route all wires to it first; then route the
wires from the box to the target device.
10. Carefully align the antenna of each S1100 device with that of its corresponding device
(S1100 or S3100) so that they have a clear RF line of sight.
11. Power up the device.
Here is a pole mount installation of an S1100 device with a PTZ camera:
Performing the RS-422/485 Serial Connection
The Nextiva edge devices support only the RS-232, RS-422, and RS-485 asynchronous
protocols. For any other protocol, you may need a converter.
Warning: At any time there must be only one serial peripheral connected to the edge
device. For instance, when configuring the device through a COM port of the
computer, you must unplug any RS-422/485 peripheral.