Verilink Wansuite 5230, Reference Manual

Page: 213 / 233

F r o n t P a n e l L C D I n t e r f a c e 5-17
DSR Data Set Ready (DSR) can be set to “True,” “False,” or “Internal.” The
“Internal” option sets DSR “On” if the port is enabled and “Off” if the port is
disabled.
Values: True, False, Internal
Default:True
DCD The Data Carrier Detect (DCD) parameter can be set to “True,” “False,” or
“Internal.” If set to “Internal,” DCD is “On” when network carrier is being
received from the remote end, and is “Off” when network carrier is not being
received from the far end.
Values: True, False, Internal
Default:True
CTS The Clear To Send (CTS) parameter can be set to “True” or “False.” If this
parameter is set to “Internal,” the CTS control lead follows the RTS control
lead from the DTE after a delay of a duration established by the RTS Delay
parameter.
Values: True, False, Internal
Default:True
RTS The Request To Send (RTS) parameter determines where the unit reads the
RTS signal status from. If set to “Normal,” the unit gets RTS from the Serial
pin. If set to “True,” RTS is always perceived as “On.”
Values: Normal, True
Default:Normal
RTS Delay The RTS Delay parameter determines how long the unit waits before it
changes the level of CTS to match RTS when the CTS parameter is set to
“Internal.”
Values: Normal (~30 ms delay), Long (~100 ms delay)
Default:Normal
Tx Clock Selects the clock the unit used to sample the data transmitted from the DTE.
When set to “Internal,” the data is sampled directly with the transmit data
clock that is also supplied to the DTE as Transmit Clock. The “External”
option uses the external clock from the DTE (valid only in Packet mode).
Values: Internal, External
Default:Internal
Inv Clock In DTE Packet mode, changes the clock edge of the data transmitted.
Values: Enable, Disable
Default:Disable
Rate If the port is running in Packet mode, the Rate must be configured to the
desired port speed. In TDM mode, the port speed rate will be set by