Verilink Wansuite 5230, Reference Manual

Page: 174 / 233

4-58 W A N s u i t e 5 2 6 0 / 5 2 3 0
Cost Represents the relative time of treatment of an IP packet. This value is used
when there are multiple routes to the same destination. When two or more
routes are available, the one with the lowest circuit cost is selected. A frame
relay circuit should have a higher value than a LAN circuit.
RIP Status Indicates whether or not RIP is enabled on this circuit.
Values: Enable, Disable
Default: Enable
Multicast Status Indicates whether or not Multicast is enabled on this circuit.
Values: Enable, Disable
Default: Enable
OSPF Status Indicates whether or not OSPF is enabled on this circuit.
Values: Enable, Disable
Default: Enable
OSPF Area Represents that area that this circuit is part of.
OSPF LSA Timer Determines how often The Link State Acknowledgment (LSA) packet is sent.
Values: 1
−
3600
Default: 5
OSPF LSU Delay The estimated number of seconds it takes to transmit a Link State Update
(LSU) packet over this circuit interface.
Values: 1
−
3600
Default: 1
OSPF Router Priority This 8-bit unsigned integer ranges from 1 to 255 and assigns priority to one of
two routers attached to the same network; without an assigned priority, both
routers attempt to become the designated router.
Values: 1
−
255
Default: 1
OSPF Hello Interval The time in seconds between the Hello packets that a router sends on a
circuit. This value is also advertised in the router’s Hello packets and must be
identical for all routers on the same network. The smaller the Hello Interval,
the sooner topological changes are detected (but then more traffic is created).
Values: 1
−
65535
Default: 10
OSPF Dead Interval The number of seconds that a router’s “Hellos” have not been received before
its neighbors declare the router down. The value must be the same as the
value on the network.
Values: 1
−
65535
Default: 40