Verilink Wansuite 5230, Reference Manual

Page: 167 / 233

V T 1 0 0 I n t e r f a c e 4-51
“No Sync” is displayed. If the receiver is in pattern sync, “In Sync” is
displayed.
Elapsed Time Displays the time elapsed since a timed test began or, if completed, the total
test time.
Bit Errors Displays the total number of bit errors detected since the test began or since
error statistics were cleared.
Errored Seconds Displays the number of asynchronous errored seconds that have been detected
since the test began or since error statistics were last cleared.
%EFS Displays the percentage of time that the test ran error-free. This ratio is
derived from the number of error-free seconds divided by the number of
seconds accumulated in Elapsed Time.
Loop Table on Network Interface Test Details Screen
The Loop table lets you specify the type of Loop test to be performed. The
types of tests available for you to choose from depend on the currently
selected interface. Loopback diagrams are displayed in Line Loopback (LLB)
and Maintenance Loopback (MLB) shown on page A-3 and Port Loop and
V.54 Loopback shown on page A-3.
Values: No Test (Loop Down), line loopback (LLB), and maintenance
loopback (MLB)
Default: No Test (Loop Down)
Figure 4.43 Serial Interface Test Details Screen
BERT Table on Serial Interface Test Details Screen
The BERT table lets you set the test parameters listed below.