Omni 3200M Installation Guide
20
Caution:
Because impact, friction, temperature, humidity,
light, and oil affect the coloring and storage characteristics of
thermal paper, handle this type of paper carefully. Never load a
roll of paper that has folds, wrinkles, tears, or holes at edges or
in the printing area. For best results, cut the leading edge of the
paper with scissors, instead of tearing it, before feeding it into
the printer.
Installing a Paper Roll
To install a roll of thermal printer paper in the Omni 3200M:
1.
Be sure the terminal is connected to a power source. (The
green LED light should be blinking off and on, indicating
that the printer needs paper.)
2.
With the terminal on a flat surface, and facing toward you,
remove the paper roll cover from the top of the terminal by
lifting up on the back of the cover. The two ridges on each
side of the black plastic cover show you where to grasp it.
3.
Remove the protective strip from a new roll of paper and
cut a clean, straight edge on the leading end of the paper.
4.
Holding the roll in your hand with the paper feeding from
the
bottom
of the roll, slowly insert the leading end into
the paper feed slot (see Figure 15).
When the built-in sensor detects the paper, the feed
mechanism engages and pulls the paper into the printer,
ejecting the end out of the top of the printer, just below the
serrated metal tear strip.
Note:
The paper feed slot is located directly above the gray
plastic paper roll cradle, and below the black plastic ridge that
extends slightly from the base of the paper feed mechanism.
Summary of Contents for Omni 3200M
Page 2: ...Omni 3200M Installation Guide...
Page 5: ......
