Rev 1.1 Cod. 00.009.123
25
3sec
Press the
ENTER/MENU
button for 3 seconds to enter
programming.
Select by the cursor the menu
Relay
and press
ENTER.
Use the ▼▲ buttons to move the cursor to the submenus.
Press
ENTER
to enter the submenu.
If you want to esc programming and return to measurement,
press the
ESC
button for 3 seconds.
ALARM
In the menu
Relay
, select by the cursor "Alarm" and press
ENTER
.
Select the desired operating mode of the relay with the ▼ ▲
buttons and press
ENTER
.
N.O = Normally Open (default value)
N.C = Normally Closed
If you want to esc programming and return to measurement,
press the ESC key for 3 seconds.
DELAY ON
In the menu
Relay
, select by the cursor "Delay On" and press
ENTER
.
Include or exclude this alarm by ▼▲ buttons and press
ENTER
.
If you want to esc programming and return to measurement,
press the ESC key for 3 seconds.
To INCLUDE OR EXCLUDE the other alarms follow the same steps of Delay On here above.
MENU DOSING
The DOSING menu
allows you to choose the type of pump dosing:
Manual, Pulses, ppm.
NB: to change the type of dosing, confirm with the
ENTER
button at least one parameter of the new dosing mode.
3sec
Press the
ENTER/MENU
button for 3 seconds to enter
programming.
Select by the cursor the menu
Dosing
and press
ENTER.
Position the cursor on the type of dosage to choose and press
ENTER
to enter to the submenu and proceed with the
modification.
If you want to esc programming and return to measurement,
press the
ESC
button for 3 seconds.
-
Manual
, the pump doses constantly at the programmed flowrate. It is possible to activate a cyclic dosage with
programmable time of delay, time of dosing (Ton) and time of not dosing (Toff).
-
Pulses
, flowrate proportional to the pulses received from a water-meter. It is possible to memorize the pulses during the
dosing
-
ppm
, flowrate automatically adjusted to reach the desired ppm level (water-meter signal)