SPREADER SETUP & INSTALL KITS
Setup - 27
3. Place the rear belting pivot brace (D) onto the
underside of the rear belting mount. Install 2)
pivot tube clamps (E) onto the rear belting mount
using 2) 1/4” x 3/4” bolts (F), 4) 1/4” flat washers,
and 2) 1/4” lock nuts at the top of the rear belting
mount and 2) 1/4” x 1” bolts (G), 4) 1/4” flat wash
-
ers, and 2) 1/4” lock nuts at the two center holes
in the rear belting mount and drop curtain. Torque
to 75 in-lbs (8.5 Nm).
F
G
G
E
E
E
E
D
D
Installation on SS300 Spreader
1. Remove the 4) bolts on the left side of the spreader
that fasten the hopper support plate and the trans-
mission mount plate to the hopper support tube.
2. Install the left drop curtain mount (H) using the
hardware removed in step 1 and adding 3) 5/16”
flat washers between the drop curtain mount and
the hopper support tube at the top two mounting
locations. Do not tighten the hardware at this time.
3.
H
H
Repeat steps 1 & 2 to install the right drop cur-
tain mount onto the right side of the spreader.
4. Install a side belting hanger (I) onto the inside set
of mounting holes on both the right and left drop
curtain mounts using 4) 3/8” x 1” bolts, 8) 3/8” flat
washers, and 4) 3/8” lock nuts. Do not tighten the
hardware at this time.
H
H
I
I
