SPREADER SETUP & INSTALL KITS
Setup - 21
7. Fasten the controller bracket (A) to the control
box mount bracket (B) using 2) #10-32 x 1/2”
machine screws and #10-32 flange nuts.
8.
A
A
B
B
Place the nylon washers on the inside of the
controller bracket and install onto the controller
using the 1/4” bolts and flat washers. Tighten the
bolts until the controller pivots with resistance.
9. Install the control box mount bracket onto the
control box bracket using 2) #10-32 x 1/2”
machine screws and flange nuts.
10. Connect the battery/controller harness to the
battery lead on the controller.
11. Connect the motor/controller harness to the
motor lead on the controller.
12. Install the wire loom over the wire harnesses and
connectors and fasten to the control box mount
bracket with a zip tie to prevent interference with
the parking brake.
13.
Zip Tie
Zip Tie
Pull any excess slack down through the steering
column and install the original bolts and wash-
ers in the remaining three holes of the steering
column. Torque 4) bolts to 100 in-lbs (11 Nm).
14. Use 2) zip ties to fasten the wire harnesses to
the wire and hose bundle on the right side of the
tunnel area.
15. Route the wire harnesses through the center
pivot area and fasten to the existing wire har-
ness under the seat with a zip tie. Check to
ensure that all linkages and moving parts do not
interfere with the wires. Correct if necessary.
