SERVICE
Service - 51
Long Term Storage (4 Months or Longer)
1. Change the engine oil to prevent damage that can
be caused by acidic build up in used motor oil.
2. Drain all fuel out of the fuel tank, start the power
unit, and allow to run until the engine stops to
ensure all fuel is out of fuel lines, carburetor
passages, etc.
3.
Turn the key to the off position and remove.
4. Engage the parking brake.
5.
Turn the fuel shut-off valve to the Off position.
6.
Turn the battery disconnect to the Off position.
7. If the power unit is being stored in a cold climate
(below 35° F (2° C)), remove the battery from
the power unit and store in a warm location.
Check the battery charge level periodically and
charge the battery, if necessary.
Short Term Storage (Less than 4 Months)
1. Add a quality fuel stabilizer to the fuel tank. Fol-
low the manufacturer’s recommended mixing
ratios. Start the power unit’s engine and run for
10 minutes to allow the fuel stabilizer to travel all
through the fuel system.
2.
Turn off the power unit engine and remove the key.
3. Engage the parking brake.
4.
Turn the fuel shut-off valve to the Off position.
5.
Turn the battery disconnect to the Off position.
6. Check the battery charge level periodically and
charge the battery, if necessary.
Removing the Power Unit from Storage
1. Clean the power unit to remove any accumu-
lated dust or debris.
2. Inspect the power unit as instructed in the daily
inspection section of this manual.
3. Test the power unit to ensure all components
and systems are working properly.
