SERVICE
Service - 44
8. Insert a new fuse into the socket. Be certain to
use the correct amperage fuse or damage may
occur to the power unit.
9. Reinstall the sealed cover onto the fuse panel.
10. Reinstall the front canvas and lower the seat
back down to the operating position.
11. Turn the battery disconnect switch to the On
position.
Replacing Fuses (Rear Fuse Panel)
1. Park the power unit on a level surface.
A
A
2. Engage the parking brake and
shut off the engine.
3. Remove the key from the igni-
tion switch.
4. Turn the battery disconnect
switch to the Off position.
5. Open the left hood panel.
6. Remove the sealed cover (A)
from the fuse panel.
7. Identify and pull the defective fuse from the socket.
8.
Rear Fuse Panel (Mini Fuse)
Position
Fuse
Circuit
1*
25 amp (CB)
Spreader
2*
30 amp (CB)
Cab
3
10 amp
Fuel Pump
4
10 amp
Diesel Stop
5
5 amp
Engine Run
6
5 amp
Speedometer
7
20 amp
Starter Relay
8*
10 amp
Spreader Vibrator
9
5 amp
Tractor Control Module 1
10
15 amp
Tractor Control Module 2
*Optional accessory.
Insert a new fuse into the socket. Be certain to
use the correct amperage fuse or damage may
occur to the power unit.
9. Reinstall the sealed cover onto the fuse panel and
close the left hood panel.
10. Turn the battery disconnect switch to the On
position.
Switching Speedometer (MPH or Km/H)
1. Park the power unit on a level surface.
2.
Engage the parking brake, shut off the engine,
and remove the key from the ignition switch.
3. Remove the steering column cover to access
the wiring for the gauges. Follow the harness
from the fuel cluster gauge to locate the green
wire (labeled A-013) with the single plug.
4. For speedometer readout in miles per hour, the
green wire (A-013) should be connected to the
wire from the gauge labeled A-020.
5. For speedometer readout in kilometers per hour,
the green wire (A-013) should be connected to
the wire from the gauge labeled A-021.
Replacing Light Bulbs (Headlights)
1.
CAUTION
The light bulb contains gases under pressure.
The bulb may shatter if the glass is scratched or
dropped. Wear eye protection and handle bulb
with care.
Park the power unit on a level surface.
2.
Engage the parking brake and shut off the engine.
3. Remove the key from the ignition switch.
4. Remove the two screws (A) from the light cover
and remove the cover.
5.
A
A
B
B
C
C
Disconnect the light bulb wire from the plug (B).
6. Pinch the wire spring fastener (C) and lift away
from the light bulb.
7. Remove the defective light bulb.
8. Install the new light bulb and secure with the
wire spring fastener.
9. Connect the light bulb wire to the plug.
10. Reinstall the light cover.